Hey Everyone, I am trying to limit access to who can access the VSP 8404’s we have on our network. Under access policies, there is default policy which I disabled and then put this: access-policy 2 *name* access-policy 2 accesslevel rwa access-po...
Hey Everyone,
I am trying to create an inPort ACL on our VSP-8404 to send traffic destined to the internet... hit a different firewall instead of the one setup as the default route.
This is what I have:
filter acl 120 type inPort name "Redirect"
f...
Hi Everyone,
Just running into a problem with SSH'ing into a a VRRP address on a VSP-8404C switch.
By default, on our old Nortel Cores... no commands are required to SSH or Telnet into the VRRP IP address. I've tried searching for Extreme VSP solut...
Hi Everyone,
Just had a question...
I am currently setting up an SPBM environment. I have a VSP-8404C setup with a x.x.x.2 address and another with a x.x.x..3 - VRRP for x.x.x.1.
When a VLAN is on both I can ping the relative x.x.x.1,2,3. But wh...
Hey Everyone,
We are migrating from our ERS-8800's to new VSP switches and I seem to be having issues with the new ACL configuration.
Previously it was set to:
filter acl 50 create inPort act 4092 name "PolicyName"
filter acl 50 ace 97 create name...
Silly question - Did you assign that ACL to the correct port?
What happens if you change eq to mask and us 10.222.12.0 0.0.0.255 and 172.16.10.0 0.0.0.31?
Hi Paul,
Nothing from NOC-Core3 and vice versa are available on either switch.
Here is the output:
show isis
====================================================================================================
ISIS General Info
...
