This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject
Help
Flavio
New Contributor III
since ‎09-07-2021
Thursday

User Statistics

  • 18 Posts
  • 1 Solutions
  • 0 Kudos given
  • 0 Kudos received

User Activity

FabricExtend through third-party IPsec tunnel - anyone tried?

Thursday
Hi all.I'm curious to know if somebody already tried to do FabricExtend through third-party IPsec tunnels. I assume it should work, given some pre-requisites eventually to be guaranteed on both ends (L2 jumbo frames, accounting for encapsulation over...

Fortigate 7.2.6 RADIUS client can't successfully test connection

02-02-2024
Hi all.Added a Fortigate as RADIUS client but from the Fortigate itself the "test connectivity" is not completing successfully.With tcpdump on the NAC engine I can see "Access-Request" but no response.RADIUS client is configured with Authentication T...

Virtual Controller and RADIUS - how to set the proxy correclty?

09-16-2020
Hi all.I’d like to have the RADIUS requests in a Virtual Controller setup only be originated from the virtual IP. As of now I tested with different proxy modes and it doesn’t work (the RADIUS packets are always sent with the physical interface IP). I...

AP7632 GUI error 403

04-03-2020
Hi there. I factory reset an AP7632 which was previously adopted by a VX9000 controller. Now I’d like to configure this AP as a VC, but I cannot connect to the GUI. It says “403 - Forbidden” and I’ve already enabled http and https in the management p...

AP aware - how is it supposed to work?

01-09-2020
Hi all. I’m wondering how “AP aware” feature is supposed to work. Is anybody using it and could share how it should be configured and intended to be used? Thanks, Flavio.
GTM-P2G8KFN