Dear all, I’m currently testing the last VOSS 8.4.1.1 version on Extreme 5520 switch. I tried to connect (telnet/ssh/https) to the switch via vlan mgmt interface from my computer (192.168.202.100/24) connected directly on the switch (port 1/24) witho...
Dear Extreme Community, Does someone have a procedure/documentation regarding how to configure/implement a Personal Home Portal on XCC version 05.06.Thanks for your help Kevin
Hello every one, I tried to setup Extreme Control on my XMC in order to see what’s connected on our network.The NAC appliance has been added to my XMC.My Switch (ERS4900 Series) has been added in “Switches” on Access Control Tab. There are two IP Pho...
Dear all, I have an issue regarding a trunk link between a VSP 7400 and ERS 4926. Ping doesn’t work..vlan config on VSP--------------------vlan members remove 1 1/1-1/48vlan create 201 name "VLAN_Gare" type port-mstprstp 0vlan members 201 1/48 portme...
Hello guys, After being enforced in NAC, I can’t add a new ERS 4926 into a new created domain , or any excisted domain. Does someone know what cause the issue? Thx
Hi @Sam Pirok, I have the same issue. I passed my third ECS certification last week. Purple Belt visible on my Dojo portal but not on my Hub portal. Could you have a look please ? Thank you in advance. Take care. Kind regards, Kevin
Hi Tomasz, Yes correct. I would like to see the end-devices in NAC.My NAC is enabled in my XMC but not in use. So that’s why I don’t know if the issue come from NAC/XMC or my switch or both.Will get a look on your documentation and thanks for your f...
Yes but I don’t find what can cause my issue. I only need the use my NAC in listen mode, on paper it’s a quick and light config In all Extreme TechTalks, Videos or documentation it’s just said to add the NAC appliance in XMC and the switch that you n...
Hi, Many thanks for your time. The host 192.168.201.211 is my NAC appliance and is reachable from my switch 192.168.204.62.I think I will start from scratch, I did a lot of tests and it’s not very clean
