Extreme Networks

I have a BD8810 connected via MLAG (ports 5:1 & 6:1) to two upstream Summit 670Vs. Ports 47-48 are the bundled ISL links between the 670Vs. The 8810 has vlan 10 whose gateway is a VRRP setup on the 670Vs. My question is, is it OK to use the ISL po...

I am trying to delete the following access-list: create access-list snmp-deny_all " source-address 0.0.0.0/0 ;" " deny ;" application "Cli" ...yet get this error when trying: MPE-8810A-ASU-MDF8.32 # del access-list snmp-deny_all Error: Dynamic r...

I have a Summit 670V switch with a /30 uplink to a Cisco router. OSPF is configured but a neighbor adjacency is not being formed. I am using MD5 authentication with a key on both sides of the link. I'm familiar with using Cisco's debug commands bu...

I have a severa; BD8810 access-layer switches connect to a Summit distribution switch. All devices have LLDP enabled on their uplink ports such as: 8810 switch: enable lldp port 5:1 configure lldp port 5:1 advertise system-name Summit switch ...

Hi - we're converting some Cisco 6509s to your BD8810 switches and I need to know how to set up QOS in EXOS, mainly on the uplinks where congestion may occur. On the Cisco switch, I use 'mls qos' and tweek the output queues a little bit, then I conf...