How to delete an access-list?

[Jim_Keeffe]

I am trying to delete the following access-list:

create access-list snmp-deny_all " source-address 0.0.0.0/0 ;" " deny ;" application "Cli"

...yet get this error when trying:

MPE-8810A-ASU-MDF8.32 # del access-list snmp-deny_all
Error: Dynamic rule snmp-deny_all has been applied to an instance
Configuration failed on backup MSM, command execution aborted!

When I do a "show config | i snmp" the only entries have to do with the access-list as shown:

MPE-8810A-ASU-MDF8.31 # sh config | i snmp
configure snmp sysName "MPE-8810A-ASU-MDF8"
create access-list snmp-164.7x.xxx.xxx " source-address 164.7x.xxx.xxx/32 ;" " permit ;" application "Cli"
create access-list snmp-deny_all " source-address 0.0.0.0/0 ;" " deny ;" application "Cli"
# Module snmpMaster configuration.
MPE-8810A-ASU-MDF8.32 #

I'm trying to delete both the snmp access-lists with no luck. Any ideas how I can do that?

[Sumit_Tokle]

Awesome!!! Have a great day.

[Jim_Keeffe]

Thanks for suggesting a synch problem. I ran synchronization on the switch (BD8810) and was then able to delete the ACLs. Cheers - Jim

[Sumit_Tokle]

* X480-48t.4 # show configuration acl#
# Module acl configuration.
#
create access-list snmp-deny_all " source-address 0.0.0.0/0 ;" " deny ;" applic ation "Cli"

* X480-48t.5 # delete access-list "snmp-deny_all"* X480-48t.6 # show configuration "acl"
#
# Module acl configuration.
#

* X480-48t.7 #

On my switch, I am able to delete the ACL using above command. I am suspecting that this ACL is not synch between both MSM and hence, giving error while deleting it.

Can you please open TAC case to further investigate on this issue?