I have a network with two cores that were dual homed but we are upgrading and breaking legs so that only one leg from the edge is connected. PIM is enabled and two 10 gig ports are LAG between Core "A" and Core "B".
If a device sending multicast on t...
I have X670 Core with LAGS set up to edge using multicast traffic, but traffic is not balancing using L2 or L3. Is there an extra config needed to balance traffic?
We actually had a port with ipmcforwarding enabled that should not have been. It was connected to our companies IT network who was blocking multicast, disabling ipmcforwarding solved the problem.
Thanks
So if there is a 2 port share and you have 2 sets of source and destination macs one set would be on one port and the next set would be on the other port.Thanks, so am I right by thinking that our two shared fiber legs are just duplicating the forwar...
Thanks for the reply. Pardon my ignorance but what do mean by ports not a good way to balance traffic. Also when you mention flows, are you referring to the physical connections or is that a programming function.
# sh sharing detail
Load Sharing Monitor
Config Current Agg Min Ld Share Dist Ld Share Agg Link Link Up
Master Master Control Active Algorithm Flags Group Mbr State Transitions
===================================================...
