I have a AP330 that stopped client access, I replaced with same AP330, same thing happened. Discovered power off/on fixes it. What may be causing this? It's located in a small room with cinder block wall, room is warm not hot.
I setup the Client Monitor, traffic will be light until Monday. I did just receive this error."The current capwap delay time higher than threshold value"
I am new to the Aerohive system. Yes the WAP reports to the manager. I can see clients but they have 0.0.0.0 as an IP. I have not concoled into a AP. I'm not familiar with "show station" command. I'll research that. Yes I'm using HM classic. a...
The light remains white. If I reboot it, it will go through the various lights until completing the boot finishing with white but it still will not let any clients to access it. I unplugged it again to see how long it take before it "locks up".