Extreme Networks

Hi Kriss,promox is officially not a supported hypervisor. You can find the supported installation methods here:https://extreme-networks.my.site.com/ExtrArticleDetail?an=000084351 I am using the ova images for xiq-se and control on proxmox without any...

Hi,you can check this Knowledge Base Entry for this task: How To: How to manually join Control appliance to domain | Extreme Portal regardsMarlon

Hi Ahmed,which version do yo use? I am not sure if the dataplane support is already fully included in gns3 fabric switches. In the past there was only controlplane support.regardsMarlon

I am using this, and its working fine. I dont think that you need the extre ' at the beginning and the end.  

Hi Jean-Noel,I faced the same issue on the 7520 and 5420. But did not open a GTAC case yet.regardsMarlon