Hi William,
Did you activated your Appliance License and applied on your VX?
If not you can refer to link below on how to activate your VX appliance license
https://extreme-networks--c.na29.visual.force.com/apex/KCSInternal?srKp=ka1&id=kA134000000G...
Hi Prabhu, in order to do this, you will need to have an ethernet loopback plug, plug into FE2 port, and power cycle your AP, you will see fast blink on your AP after few seconds boot up, after that , your AP7502 is being factory default.
In other w...
Hi Niyas,
Good day,
In your controller ge port, you will need to allow vlan 18 to go through, and for other vlan that you create for SSID (vlan 22,24,33, and 34) you will need to use NAT to vlan 18 to enable them access to internet.
Thank you
