Andrew_Schulz1
New Contributor
since ‎09-07-2021
‎08-30-2022

User Statistics

  • 17 Posts
  • 0 Solutions
  • 1 Kudos given
  • 0 Kudos received

User Activity

I've configured a private VLAN for ports 1 and 2 so that they are isolated from one another. The configuration shown below is how I set it up, however, when I place a client on port 1 I can not ping the gateway.The client can ping the VLAN Mgmt99 IP...
I have a stack of x450e switches and I recently updated the XOS. When I do a Show Version it shows the two slots with different Rev #'s. Rev 10 is the correct version but slot 2 shows Rev 7. Also, the BootROM is different. Is that normal, and if not ...
I have several x450e switches being used as access switches for phones, clients and a few Wifi APs. I would like to tighten security on these switches, I've done the standard RADIUS AAA, disabled telnet and http and only allow access by AD group via ...
I have a X450e that I am linking a Cisco 2960S too. Both ports are in VLAN 99 (management). They are not able to talk to each other and I am not able to access the Cisco switch by the IP assigned to VLAN 99. Cisco Config interface GigabitEthernet1/...
We have a limited budget available and I need 48 port Gigabit PoE switches and these look really good, but I'm concerned that they are discontinued. I want to know if they are still supported by technical support. Also, are the firmware updates stil...
Kudos given to
GTM-P2G8KFN