Hello Guy,
how to translate these commands from Enterasys to Extreme 460?
i haven't found the right command and no port on this so far.
ip forward-protocol udp 2009
ip forward-protocol udp 3001
thanks in advance
Hello support,
I’m trying to update a netsight where the Root user is not accessible (password not known!).
But the netsight itself is accessible over another user, but I’m getting following error:
“this Application must be run...
Hello everyone,
I’m facing a simple issue actually with purview (Virtual Node)
purview is configured accordingly, netflow traffic are being received but the application response time is still missing. No traffic are being received over ...
Hello
guys,
if I’m not mistaken, the Exnterasys B3 Switche for example are per Default set to accept only policy.
With the following command, one can set it to also accept the vlan-tunnel-Attribute.
“Set policy maptable response bot...
Hello,
the NAC Manager is not displaying the Serial number of my NAC Gateway:
NAC-V-20 and NAC-V
even tying with some shell command, i couldn't find it out.
any hint how to show to Serial number?
Many Thanks
for those facing the same issue, i used this guide here:
http://documentation.extremenetworks.com/exos/EXOS_21_1/IPUnicast/t_configure-udp-forwarding.shtml
my goal is to allow some ports which are not allowed by Default...
following is already implemented:
""""
configure bootprelay add vr VR-Default
enable bootprelay ipv4 vlan
"""""
what is missing is to allow the relay over UDP port 2009 and 3001.
...
