ip forward-protocol from Enterasys syntax to Extreme
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-09-2017 08:11 AM
Hello Guy,
how to translate these commands from Enterasys to Extreme 460?
i haven't found the right command and no port on this so far.
ip forward-protocol udp 2009
ip forward-protocol udp 3001
thanks in advance
how to translate these commands from Enterasys to Extreme 460?
i haven't found the right command and no port on this so far.
ip forward-protocol udp 2009
ip forward-protocol udp 3001
thanks in advance
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-10-2017 07:51 AM
for those facing the same issue, i used this guide here:
http://documentation.extremenetworks.com/exos/EXOS_21_1/IPUnicast/t_configure-udp-forwarding.shtml
http://documentation.extremenetworks.com/exos/EXOS_21_1/IPUnicast/t_configure-udp-forwarding.shtml
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-10-2017 07:49 AM
thanks a lot. issue solved. regards
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-09-2017 08:51 AM
UDP profiles should be used for that, assuming it is udp broadcasts to these ports.
https://gtacknowledge.extremenetworks.com/articles/Solution/UDP-broadcast-packets-are-dropped-by-EXO...
https://gtacknowledge.extremenetworks.com/articles/Solution/UDP-broadcast-packets-are-dropped-by-EXO...
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-09-2017 08:22 AM
my goal is to allow some ports which are not allowed by Default...
following is already implemented:
""""
configure bootprelay add vr VR-Default
enable bootprelay ipv4 vlan
"""""
what is missing is to allow the relay over UDP port 2009 and 3001.
Any help is appreciated.
Thnaks
following is already implemented:
""""
configure bootprelay add
enable bootprelay ipv4 vlan
"""""
what is missing is to allow the relay over UDP port 2009 and 3001.
Any help is appreciated.
Thnaks
