Hi,I am not able to access Brocade MLXe8 switch through console although I am using the native console cable with the converter and valid session parameters.it shows connected but no data on screen please advice
hello,I have two core switches both are active “in cluster” running without any issue and i tried two differnt console cables with no luck however same converter works fine for other switches model.attached screen shot of the used cabelalso I tried M...
I have two core switches so you mean to reboot one by one and monitor the serial connection ?what about management port ? is there any option to connect my laptop with mgmt port if there is default mgmt IP address for same model
Hello ,Actually I need to access it through console to reset it to factory configuration (write erase) so even if there is other way like magmt port or hard reset it will be fine please note that access though telnet or ssh is not possible currenty!
