Extreme Networks

hatankkt · 06-18-2019

this one of the log U-Boot 2012.10 (Apr 27 2019 - 23:37:32) I2C: readyWait.Done.DEV ID= 0000cf12REV ID= 00000000SKU ID = 0OTP status: eca00018MEMC 0 DDR speed = 800MHzLog: ddr40_phy_init.c: Configuring DDR Controller PLLsLog: offset = 0x18010800Log...

hatankkt · 06-19-2019

Thanks for answering both. But in my case,another AP250s (the same firmware version 8.0r1) are getting power from same PoE switch and boots well .And device was in version 10.0r5 before, even that time also it was showing the same behavior.If there ...

Extreme Networks

User Statistics

User Activity

Hi,I have an access point ap250(firmware version is 8.0r1) ,but not work.the ap reboot cycles and hand in middle. When I try to pull out PoE cable,sometime go well,but after a few seconds,the ap reboot and hang up.

Re: Hi,I have an access point ap250(firmware version is 8.0r1) ,but not work.the ap reboot cycles and hand in middle. When I try to pull out PoE cable,sometime go well,but after a few seconds,the ap reboot and hang up.