Extreme Networks

Humza · 05-14-2020

Hi, hope you’re all well. I currently have an MLAG configuration in a standard setup on a pair of X670 switches, that is 1x 10G member in each switch. We now have a requirement for some additional bandwidth on the same bond, and I am having trouble f...

Humza · 03-21-2018

Howdy, I am currently testing two C35 controllers - as part of our testing we were able to get some access points provisioned fine on a subnet existing on the two controllers in a HA pair. However, I have been trying to get the access points to pro...

Humza · 05-15-2020

enable sharing 42 grouping 42 algorithm address-based L2 lacpconfigure sharing 42 lacp timeout shortcreate mlag peer "sw-02" configure mlag peer "sw-02" ipaddress 172.16.0.2 vr VR-Default enable mlag port 42 peer "sw-02" id 42 It’s a fairly basic con...

Humza · 03-21-2018

Ah, thank you Craig. It wasn't obvious from the documentation that the administration / management port could not be used for AP registration. I'll give this a go now.

Humza · 03-21-2018

Default route was already set, and the controller can be curl'ed successfully on port 5825 and for testings sake the AP is on the same subnet as the management interface of the controller so that wouldn't make any difference.

Humza · 03-21-2018

Thanks Doug, That is exactly what I've done a few times already. The controller IP address appears fine in the configuration file but it can't seem to connect to the controller, even though I'm able to curl the controller on port 5825 just fine. Mar...

Humza · 03-21-2018

Unfortunately, exactly the same issue here.

Extreme Networks

User Statistics

User Activity

X670 Switching MLAG with more than 2 members

DHCP option 78 with multiple controllers?

Re: X670 Switching MLAG with more than 2 members

RE: DHCP option 78 with multiple controllers?

RE: DHCP option 78 with multiple controllers?

RE: DHCP option 78 with multiple controllers?

RE: DHCP option 78 with multiple controllers?