Hello, I have configured the cir-rate to 4000000000 bps and added this to the port-channel. (outbound)As I checked Interface stats, the port-channel TX Mbits/Sec is 8G, and the two physical interfaces are 4G each.port-channel protocol is vLAG.Is it c...
I want to apply ACL to VDX ISL port.
However, the following error message occurs when applying:
Bottom_SW1(conf-if-fo-1/0/49)# ip access-group Test_ACL out
%% Error: Edgeport configurations are not allowed on ISL ports.
Shutdown interface to apply s...
I was unable to specifically find the OID I wanted in the MIB Reference Manual.
The firmware versions for VDX devices are NOS 6.0.2f and 6.0.2g.
Does the NOS MIB have OID values for ARP tables and MAC address tables?
I need the HW information for VDX device.
Not clearly stated in data sheet.
1. Target device
- VDX 8770-8
- VDX 8770-4
- VDX 6740T
- VDX 6740
2. Necessary information
- Information on the Installed Process CPU
- Maximum capacity of installed ...
I'm sorry to confuse you.I think my LACP explanation was insufficient. I wanted to know if there was a difference in the interface to which Cir-rate is assigned under the two conditions below. Two port-channel members are configured in two R-brides. ...
Our NOS versions are 6.0.2g and 6.0.2ha.It is production traffic and has difficulty adding member port of port-channel. I expected that if we apply cir-rate of 4000000000 bps (Up to 4000 Mbits/Sec) to port-channel, the TX,RX limit of port-channel is ...
Hi Truyen,Thank you for your kind reply. Does it mean that cir-rate is assigned to each physical interface due to the 'permit any any' configuration? I modified the ACL and tested it, but the results are the same. Is it normal for the cir-rate to be ...