Extreme Networks

Jaroslav_Stefan · 07-15-2015

Hello, I have a few questions about private vlans configuration. Firts of all topology: Router1 - with several VLAN and with vlan9 (IP: 192.168.9.1/24) Switch 1 (Extreme summit X440; XOS: 15.6.1.4) - which si directely connected to Router1 throw trun...

Jaroslav_Stefan · 08-29-2018

Hi, just follow up. Purpose of this comment is to share a knowledge how to get more user friendly configuration of Extreme Management Center. Start position: - fresh install of ExtremeManagementControl (EMC) on RHEL (v7) or Centos server (v7) - ava...

Jaroslav_Stefan · 03-21-2018

I suppose that you have tested your ntp server via ip6 with another client on "another" network e.g. throw direct connection? Are you able to ping this server with ip6? Can we see output of sh vlan?

Jaroslav_Stefan · 02-08-2018

You must specify the very same vlan tag and name which was was previously defined in the radius server. This vlan must be present in switch as well. Also I would suggest to use configuration without no-restart port options (but it depends on your con...

Jaroslav_Stefan · 02-06-2018

OK, I am suppose that you are able to ping your radius server and also username and password which are used for communication with radius server are correct!? Could you also please share output of these commands: sh config | inc netloging sh config ...

Jaroslav_Stefan · 02-06-2018

Interesting...Everything looks good. Could you please share output of this command: show config | include netlogin (it is slightly different than sh config | include radius) and show vlan

Extreme Networks

User Statistics

User Activity

Private vlans config

RE: Force NetSight to use HTTPS

RE: IPv6 NTP woes

RE: 802.1x failing but radius authentication succeeded

RE: Configuring Radius Authentiction

RE: 802.1x failing but radius authentication succeeded