Hi There,
I found MPLS route is still active in routing table even its corresponding OSPF route is not listed in routing table.
Ori Destination Gateway Mtr Flags VLAN Duration
mp 192.17.80.55/32 172.17.79.1 ...
OK. If you say so. I used to contact GTAC but now, I am really fed up with their support. They kept asking to provide output of cmd again and again. I better save time by looking workaround solution.
Due to the privacy, I can't share the output you...
Yes, mpls-next-hop is turned on as follow.
DR1.6 # show configuration | inc next-hop
enable ospf mpls-next-hop
DR1.7 #
And also CR1-DR1_901 is directly connected to 192.17.80.55 but its ospf cost is set to 40 where the primary link CR1-DR1_782 is...
The question being is why following mpls route is shown in routing table in the first place ?
mp 192.17.80.55/32 172.17.79.1 1 U--D---um-L-- CR1-DR1_902 0d:2h:57m:41s
Since there is only one ospf route (best route) is selected, there sh...
Let me elaborate. Even only the single OSPF route is there, the path is chosen based on the mpls routes. There are two mpls routes as you can see in the output shared above, the first mpls route is taken as primary active path (its corresponding OSPF...
Hi Grosjean,
Thank you for your explanation and really appreciate it. As per following snippet, can I confirm the path to PE2 is preferring via OSPF even though there is mpls ldp for the same destination ?
Does it mean the forwarding will be via...
