Extreme Networks

no sure, it is requested by extreme support to put in these commands after upgrade to 15.5.3 patch 1-2

it is not 10G port, but the 1G data ports that are flapping. I have upgraded to 15.5.3 patch 1-2. #configured stack-port debounce time 150 #debug hal configure stack-ports pre-emphasis 7 driver-current 9 anyone faced similar issue?

should we applied debounce 150 to all data ports too? Extreme support advise that it should be applied to port that are flapping only. is that right?

Hi there, after we upgraded the switch firmware and applied debounce time 150 to stack ports, the stack ports flapping issue was resolved. However, I did observed some flapping for data ports. No sure if anyone noticed this issue.

hi martin, did you managed to resolve the issue? I having the same issue with x460 now