Setting up Summit x440 as DHCP server.
Looking for the syntax, or reference material for Avaya options.
This is the string used in MicroSoft or QIP DHCP.
“MCIPADD=#.#.#.#,MCPORT=1719,TFTPSRVR=#.#.#.#,L2Q=1,L2QVLAN=0″
Should I configure ELRP on ports that have been setup with LACP? I have 2 Summit switches with MLAG, and ports 48 on each switch are set for LACP. A server will have a connection to each port. Or will ELRP disable the port by default.
100 meters maximum for copper - around 300 feet. Also, look at the POE switch - if using a Cisco 3560 for POE, only half of the switch can be used before the available POE wattage runs out. You can also try adjusting the POE threshold on the switch...
Thank you Jeremy. That will work, I'll ask the client for the IP office IP address. Second question, which is probably a no or at least not best practices. I have a client that has given me one vlan, to use for both voice and data. Let's say 10 d...
