Extreme Networks

Not_Very_Good · 05-18-2022

Hello Everyone,I'm trying to automate a simple task of turning some port up/down with a script. Where I'm getting stuck is when I try add a pause. This is what I have:show port 12 configuration no-refreshdisable port 12#timer 1enable port 12show port...

Not_Very_Good · 02-15-2022

Hello Everyone,I'm new to Extreme and am looking for some guidance. I have been working on creating a standard image for our 5520 switches and have been able to do so except for one thing, changing a VLAN IP address automatically. What I have so far ...

Not_Very_Good · 11-06-2023

It's always simple things in this field. Glad you were able to resolve this!

Not_Very_Good · 08-11-2023

My concern with the optic is compatibility. If I read this right, you going from a Dell switch to an Extreme switch. I've seen where an optics firmware will not work with a brand of switch. Matter of fact I once spoke with Fujitsu and they straight u...

Not_Very_Good · 08-10-2023

FWIW, I am doing an upgrade from the 440 model to 5520 series and have had a similar issue. I'm guessing, cause I hate to assume, your VLANs match on both ends, etc.. If this is true, I'd suggest swapping optics on both sides. This was my issue even...

Not_Very_Good · 12-28-2022

I also run version of GNS3 with Extreme virtual switches. I found that this is a limit with the virtual image. My guess is that this is done to reduce the load placed on your PC so you can still do other things.

Not_Very_Good · 09-07-2022

I have found a solution this using UPM commands.

Extreme Networks

User Statistics

User Activity

Add wait time to xsf file

Run Script at Boot?

Re: Can't get a new 5400 to use SFP module uplink

Re: Can't get a new 5400 to use SFP module uplink

Re: Can't get a new 5400 to use SFP module uplink

Re: Virtual EXOS port limitation?

Re: Add wait time to xsf file