Extreme Networks

Johan_Brand · 03-27-2018

We've been doing some office renovations and got a few new cat6 points installed. I have two points next to each other on a wall with one of the points not working. When patched to the switch (220-24p) the LED on the port flashes amber slowly. What...

Johan_Brand · 01-30-2018

We have about 30 x 220 series switches installed at our sites. After +- a week SSH access to the switches stops working completely. We have telnet disabled and only ssh access enabled. Rebooting always resolves the issue. Running latest firmware at t...

Johan_Brand · 05-03-2018

Hi Larry Thanks for the LED meanings - Mine was doing the slow blinking amber. In the end the issue was related to a faulty cable.

Johan_Brand · 03-27-2018

Hi Brian Replacing the cable at this stage is what I'm trying to avoid as it's close to 100meters. Thanks for the explanation of the Short error status as this might be the answer then... I assumed it might mean the length of the cable is "short" ...

Johan_Brand · 02-01-2018

Thanks - Noticed that it stops working either after 3 or 4 days of up-time.

Johan_Brand · 01-30-2018

Hi Jason and Michael I'm using trusty old Putty - but I have not tried using anything else. It takes about a week for the issue to reoccur. All our switches was rebooted on the 26/01 so the issue should present itself later this week. I am the ...

Extreme Networks

User Statistics

User Activity

220 LED patterns

SSH stops working on 220 series switches

RE: 220 LED patterns

RE: 220 LED patterns

RE: SSH stops working on 220 series switches

RE: SSH stops working on 220 series switches