ExtremeWireless (WiNG)

 View Only
  • 1.  NX5500 Controllers

    Posted 06-10-2022 04:54
    We are currently running an NX5500 cluster in activ/standbuy mode version 7.5.1 we would like to change it to activ activ what do i need to do to make that happen?


  • 2.  RE: NX5500 Controllers

    Posted 06-13-2022 08:26
    Hello OGB,

    May we ask about the reason behind this request?

    Thank you,

    ------------------------------
    Christoph S.
    ------------------------------



  • 3.  RE: NX5500 Controllers

    Posted 06-13-2022 09:53
    I was told by support that they do not recommend doing that.


  • 4.  RE: NX5500 Controllers

    Posted 06-14-2022 12:29
      |   view attached
    Hello OGB-NIKO,
           The following is from our Wing Clustering document:

    Active / Active or Active / Standby
    The configuration of your cluster will require a mode to be established for the desired operation within your environment.

    In a large enterprise / NOC deployments with several thousand or more Access Points, the cluster mode must be set to Active / Standby in order to maintain statistics and other information in the UI / CLI. Active / Active should only be used in small / medium size campus deployments with MINT tunneling where Access Point load balancing will actually provide a benefit. Other deployments will not benefit from Active / Active setup whatsoever.

    The general recommendation is to keep clustering in Active / Standby for most of deployments for fault tolerance, ease of troubleshooting. Note that Active / Active clustering is not supported for the NOC controllers managing remote sites.

    I have uploaded the latest Wing Clustering Guide, which has everything you require for Wing clustering (Active/Active or Active/Standby).

    Attachment(s)

    pdf
    WiNG_Clustering.pdf   772 KB 1 version


  • 5.  RE: NX5500 Controllers

    Posted 6 days ago
    Thank you for helping people get the information they need. Great stuff as usual. Keep up the great work!!!


  • 6.  RE: NX5500 Controllers

    Posted 5 days ago
    I also have this same question and I cannot find any proper answers on the internet and also need a solution. Works like a charm!  MyAtriumHealth