How to replace a failed switch in a stack?

  • 0
  • 1
  • Question
  • Updated 1 year ago
  • Answered
I have two x460-48t switches configured in a stack. I want to create a procedure for replacing one of them if it fails. I searched and found a similar question from a year ago. But the document that was offered as a solution is no longer available to download. Can someone please help me out?
We will have a spare running the same XOS on the same partition as the active/backup nodes. So we can remove the failed node and install the spare. The necessary commands to add the new node and synchronize the stack is what I'm not clear on.  Thanks a lot
Photo of Justin Schmidt

Justin Schmidt

  • 220 Points 100 badge 2x thumb

Posted 3 years ago

  • 0
  • 1
Photo of Doug Hyde

Doug Hyde, Technical Support Manager

  • 20,514 Points 20k badge 2x thumb
Official Response