learned mac address refer to group

  • 0
  • 1
  • Question
  • Updated 3 weeks ago
I have created a DEVICE GROUP with ITS INTERNAL only two port/pc so I STARTED the flexview "learned mac addresses" to know if the 2 pc are turned on but my view show nothing.


Photo of Visconti

Visconti

  • 764 Points 500 badge 2x thumb

Posted 3 weeks ago

  • 0
  • 1
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 49,972 Points 20k badge 2x thumb
Did you click on the green play button icon in the upper right corner of this screen to start the query ?!
Photo of Visconti

Visconti

  • 764 Points 500 badge 2x thumb
Yes absolutely!
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 49,972 Points 20k badge 2x thumb
Does it work if you run it on the whole switch isntead of an port group ?


Photo of Visconti

Visconti

  • 764 Points 500 badge 2x thumb
YES ! but I need to show  only the computers in that group
otherwise what is the purpose of creating groups?
(Edited)
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 49,972 Points 20k badge 2x thumb
Calm down... I only wanted to make sure that it works in general before adding a device group.
Photo of Visconti

Visconti

  • 764 Points 500 badge 2x thumb
Sorry :-) I am calm with you ..... I am less calm with Netsight !!
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 49,972 Points 20k badge 2x thumb
I get the same result..... I'd open a GTAC ticket as I'm not sure whether that will work with this flexview.
Photo of Visconti

Visconti

  • 764 Points 500 badge 2x thumb
I'm afraid so :-(