multiple entries for same vlan in policy manager

  • 0
  • 1
  • Question
  • Updated 5 months ago
  • Answered
We are attempting to create authentication by 802.1x send devices to several contain to vlan policies; we are not sure why there are multiple entries for the same vlan after adding the new vlans to the switches.  We were told by the Extreme tech to run "set vlan create ##" on each switch - I don't know if that caused the multiple entries or if I did something else wrong.
Photo of Seth Bean

Seth Bean

  • 250 Points 250 badge 2x thumb

Posted 5 months ago

  • 0
  • 1
Photo of Ronald Dvorak

Ronald Dvorak, Embassador

  • 51,328 Points 50k badge 2x thumb
Could you post a screenshot of the CLI ouput so we'd have a better unterstanding of the issue.
Photo of Seth Bean

Seth Bean

  • 250 Points 250 badge 2x thumb
This is found in the GUI of Policy Manager, not CLI. I created the VLANs on each switch, but upon some research I believe I was given bad advise and should have added the VLANs via the Primary VLAN Model in VLAN Elements Editor.