problem with Config Booted on summit x450-g4

  • 0
  • 1
  • Problem
  • Updated 2 years ago
  • Not a Problem
when i configured switch this save configuration but if the switch reboot lost the configuration, i can see this configuration in the switch:

information on SW
####################
Slot:             Slot-1 *                     Slot-2                                    ------------------------     ------------------------
Current State:    MASTER                       BACKUP (In Sync)        

Image Selected:   secondary                    secondary               
Image Booted:     secondary                    secondary               
Primary ver:      16.1.0.18                    16.1.0.18               
Secondary ver:    22.1.1.5                     22.1.1.5                

Config Selected:  primary.cfg                                          
Config Booted:    Factory Default                                      

primary.cfg       Created by ExtremeXOS version 22.1.1.5
                  577404 bytes saved on Fri Jan 13 20:33:50 2017
Photo of Salvador Gallo

Salvador Gallo

  • 452 Points 250 badge 2x thumb

Posted 2 years ago

  • 0
  • 1
Photo of Patrick Voss

Patrick Voss, Alum

  • 11,594 Points 10k badge 2x thumb
Hello Salvador,

You checked the "show config" to see if the config is missing? This is a stack, did you reboot the entire stack?
Photo of Salvador Gallo

Salvador Gallo

  • 452 Points 250 badge 2x thumb
yes, i reboot the stack and the config lost, yesterday config this in the sw:

BootRom > config none
BootRom > boot

after this config the switch lost the config the switch up with  factory default


Photo of Patrick Voss

Patrick Voss, Alum

  • 11,594 Points 10k badge 2x thumb
Is there a reason you went to the bootrom and config none?
Photo of Salvador Gallo

Salvador Gallo

  • 452 Points 250 badge 2x thumb
i need to restore to factory and in enterasys this was the procedure and i suppose that the process was the same
Photo of Patrick Voss

Patrick Voss, Alum

  • 11,594 Points 10k badge 2x thumb
Hello Salvador,

Can you explain the order of events? Config, Bootrom, Reboot?

unconfigure switch all will factory restore the configuration in exos. This is assuming you can login.
(Edited)
Photo of Salvador Gallo

Salvador Gallo

  • 452 Points 250 badge 2x thumb
is all 
Photo of Patrick Voss

Patrick Voss, Alum

  • 11,594 Points 10k badge 2x thumb
In what order?
Photo of Salvador Gallo

Salvador Gallo

  • 452 Points 250 badge 2x thumb
ok, in this case reboot the switch and them press space bar and put de command config none and reboot, after when i configure save configuration and reboot the switch lost the configuration
Photo of Tripathy, Priya Ranjan

Tripathy, Priya Ranjan, ESE

  • 2,306 Points 2k badge 2x thumb
Please emphasize on the order in which it was accessed......We knew t hat you had factory defaulted the switch to unconfigure all.
Photo of Prashanth KG

Prashanth KG, Employee

  • 5,300 Points 5k badge 2x thumb
HI Salvador,

As per the output of show switch, the switch is booted with the "factory default" configuration.
If we reset the switch with the command below,

BootRom > config none

This is an expected behaviour that the switch will boot with the factory default configuration after the command above in the bootrom.

Config Selected:  primary.cfg                                       

We might have a problem if you jus reboot the stack now and if it not loaded with the primary.cfg as mentioned above. So, please clarify the issue so that we can help you further.

Thanks.