problem with Config Booted on summit x450-g4

[Salvador_Gallo]

when i configured switch this save configuration but if the switch reboot lost the configuration, i can see this configuration in the switch:

information on SW
####################
Slot: Slot-1 * Slot-2 ------------------------ ------------------------
Current State: MASTER BACKUP (In Sync)

Image Selected: secondary secondary
Image Booted: secondary secondary
Primary ver: 16.1.0.18 16.1.0.18
Secondary ver: 22.1.1.5 22.1.1.5

Config Selected: primary.cfg
Config Booted: Factory Default

primary.cfg Created by ExtremeXOS version 22.1.1.5
577404 bytes saved on Fri Jan 13 20:33:50 2017

[bini]

hello Salvador 

Did you solve the issue?

[Prashanth_KG]

HI Salvador,

As per the output of show switch, the switch is booted with the "factory default" configuration.
If we reset the switch with the command below,

BootRom > config none

This is an expected behaviour that the switch will boot with the factory default configuration after the command above in the bootrom.

Config Selected: primary.cfg

We might have a problem if you jus reboot the stack now and if it not loaded with the primary.cfg as mentioned above. So, please clarify the issue so that we can help you further.

Thanks.

[Tripathy__Priya]

Please emphasize on the order in which it was accessed......We knew t hat you had factory defaulted the switch to unconfigure all.

[Salvador_Gallo]

ok, in this case reboot the switch and them press space bar and put de command config none and reboot, after when i configure save configuration and reboot the switch lost the configuration