06-05-2019 06:44 AM
Hello ,
AP230/10.0r5
12dc/2A
Eth1 : Uplink Port.
Eth0: Access Port.
Client (Andriod) can't connect to the eth0 .
show interface eth0:
Parent interface=none;
Mode=bridge-access; Mac learning= enabled; Admin state=enabled;
WEB server=disable; NAT support=disable; DHCP client=disable; DHCP server=disable; DNS server=disable;
IP addr=0.0.0.0; Netmask=0.0.0.0;
Internal station traffic state=enabled;
Operational state=down; Duplex=unknow; Speed=unknow;
LLDP state=enabled; CDP state=enabled;
Hiveid="VHM******"; Vlan=1;
MAC addr=d854:****:****; MTU=1500;
Rx packets=0; errors=0; dropped=0;
Tx packets=5; errors=0; dropped=0;
Rx bytes=0 (0 B); Tx bytes=906 (906 B);
How to make eth0 works ?
Thanks.
Solved! Go to Solution.
06-14-2019 02:52 PM
Hello Sam,
I figured it out.
My ap230's eth0 is broken.
Thank you for your help.
06-14-2019 02:52 PM
Hello Sam,
I figured it out.
My ap230's eth0 is broken.
Thank you for your help.
06-06-2019 10:57 PM
Thanks for your reply.
I tried to set the eth0 for uplink. It doesn't work too, eth0 can't get connection form Router/Switch.
And then i changed the power source to Poe(Juniper switch/ Avaya poe injector ), Ap230's status light goes amber(steady) , also can't connect to Router/Switch.
Reset the AP to default , DC 12V/2A or Poe , eth0 for uplink , still can't connect to router/switch.
So i can only use eth1 for uplink now .
06-06-2019 04:26 PM
Would you be able to send some tech data from this AP? If you'd like to send that to me directly, my email is communityhelp@aerohive.com. Also, typically we see the ETH1 port for access, and the ETH0 for uplink, is there a reason you're using ETH0 for access instead? It should work, I'm just curious about the needs behind that decision.