AP230's eth0 can't work as access-port.

[mei8hty]

Hello ,

AP230/10.0r5

12dc/2A

Eth1 : Uplink Port.

Eth0: Access Port.

Client (Andriod) can't connect to the eth0 .

show interface eth0:

Parent interface=none;

Mode=bridge-access; Mac learning= enabled; Admin state=enabled;

WEB server=disable; NAT support=disable; DHCP client=disable; DHCP server=disable; DNS server=disable;

IP addr=0.0.0.0; Netmask=0.0.0.0;

Internal station traffic state=enabled;

Operational state=down; Duplex=unknow; Speed=unknow;

LLDP state=enabled; CDP state=enabled;

Hiveid="VHM******"; Vlan=1;

MAC addr=d854:****:****; MTU=1500;

Rx packets=0; errors=0; dropped=0;

Tx packets=5; errors=0; dropped=0;

Rx bytes=0 (0 B); Tx bytes=906 (906 B);

How to make eth0 works ?

Thanks.

[mei8hty · Accepted solution]

Hello Sam,

I figured it out.

My ap230's eth0 is broken. 

Thank you for your help.

[mei8hty]

Thanks for your reply.

I tried to set the eth0 for uplink. It doesn't work too, eth0 can't get connection form Router/Switch.

And then i changed the power source to Poe(Juniper switch/ Avaya poe injector ), Ap230's status light goes amber(steady) , also can't connect to Router/Switch.

Reset the AP to default , DC 12V/2A or Poe , eth0 for uplink , still can't connect to router/switch.

So i can only use eth1 for uplink now .

[samantha_lynn]

Would you be able to send some tech data from this AP? If you'd like to send that to me directly, my email is communityhelp@aerohive.com. Also, typically we see the ETH1 port for access, and the ETH0 for uplink, is there a reason you're using ETH0 for access instead? It should work, I'm just curious about the needs behind that decision.