Aerohive Migrated Content - Page 107 - Extreme Networks

Aerohive Migrated Content

Questions and discussions related to old aerohive products migrated over

Forum Posts

Sorted by:

Start a conversation

The EOL document shows the AP305C as the replacement for the AP245X. The 245X specifically lists available patch antennas(60 or 120degree). The antennas listed for the AP305CX & AP510CX are dipole antennas. Is there a patch option for these?

The EOL document shows the AP305C as the replacement for the AP245X. The 245X specifically lists available patch antennas(60 or 120degree). The antennas listed for the AP305CX & AP510CX are dipole antennas. Is there a patch option for these?

We're currently running HiveManager Online (Classic?) with a mix of AP330, AP390, AP250. I'm planning on deploying the newer ExtremeWireless AP410C or AP510C. Will either/both of the newer APs work on the older Hivemanager (8.2r2e)?

We're currently running HiveManager Online (Classic?) with a mix of AP330, AP390, AP250. I'm planning on deploying the newer ExtremeWireless AP410C or AP510C. Will either/both of the newer APs work on the older Hivemanager (8.2r2e)?

A customer tries to upgrade AP130 from 8.2r4 to 10.0r7a, but the HM says "Device Update Failed" and "Could not download configuration". The AP then goes off-line. Is there a known issue with this version and AP130? What can we do to resolve the probl

A customer tries to upgrade AP130 from 8.2r4 to 10.0r7a, but the HM says "Device Update Failed" and "Could not download configuration". The AP then goes off-line. Is there a known issue with this version and AP130? What can we do to resolve the probl

Resolved! Is it possible to disable the WebUI on access points via policy?

Hello everybody, is it possible to disable the WebUI on access points via policy? I didn't find any menu where i can do this configuration. I just found this option if i select one access point under the tab "monitor" and click the "edit" button. On...

AP CLI - Command to "expand"/auto-size a property (instead of having the three dots)

Sorry to bother again, I was wondering if there is a command in HiveOS which can "expand" the three dots at the end of a line. When I run "show interface", the last column (SSID) shows a lot of truncated names (like "BSB_STU...", "BSB_PRI...", etc.)...

Top Kudoed Authors

User

Count

4

3

3

3

2

GTM-P2G8KFN