I bought 4 aerohive AP250. But, I don't know how to configurations.
my config are below.
AH-518e40#show config running
no system led power-saving-mode
interface mgt0 ip 10.230.10.235 255.255.255.0
ip route net 0.0.0.0 0.0.0.0 gateway 10.230.10.1
no interface mgt0 dhcp client
dns server-ip 8.8.8.8
capwap client server port 80
capwap client server name 10.230.10.234
capwap client transport HTTP
And capwap config are below.
AH-518e40#show capwap client
CAPWAP client: Enabled
CAPWAP transport mode: HTTP on TCP
DISCOVERY state: Sending Discovery packets to find the CAPWAP server
CAPWAP client IP: 10.230.10.235
CAPWAP server IP: 54.172.0.252
HiveManager Primary Name:10.230.10.234
HiveManager Backup Name:
CAPWAP Default Server Name: redirector.aerohive.com
Virtual HiveManager Name:
Server destination Port: 80
CAPWAP send event: Enabled
CAPWAP DTLS state: Enabled
CAPWAP DTLS negotiation: Enabled
DTLS next connect status: Enable
DTLS always accept bootstrap passphrase: Enabled
DTLS session status: Disconnect
DTLS key type: passphrase
DTLS session cut interval: 5 seconds
DTLS handshake wait interval: 60 seconds
DTLS Max retry count: 3
DTLS authorize failed: 0
DTLS reconnect count: 0
If I want access manager, How can I do that?
unable to access 10.230.10.234
