Network 360

[AnonymousM]

Looking at Network 360 in the device section, I advice that the parameter "Adequate Power Supply" is red, how should I consider this value?

[AnonymousM · Accepted solution]

Resolved by the customer enabling lldp on the switch. all APs negotiated at POE+ mode.

[AnonymousM]

[AnonymousM]

I also have this issue. My score is 79. Made up of 5 AP250 and 3 AP550. The switch is C2960-X 48 port 720W POE+. I am unsure what else is consuming power on this switch.

We are having VoIP delay issues.

This Device-Monitor-Wired Interfaces reports a green tick in Eth0

i will run that cli command.

[AnonymousM]

This thread, https://thehivecommunity.aerohive.com/s/question/0D50c00006qX8kWCAS/ap550s-are-running-in-af-power-mode, might be worth a read. Only because there was some odd behavior between Aerohive APs and Aruba switches.