cancel
Showing results for 
Search instead for 
Did you mean: 

Poor performance on AP 130 devices and high interference alerts

Poor performance on AP 130 devices and high interference alerts

itadmin5
New Contributor

We have 6 AP 130's that have started having performance issues ( ethernet is fine) and have been receiving high interference alerts (unsure if related as my actual knowlege of how AP's work is limited)

 

On one device I ran: show interface wifi1 _counter

 

519031970 rx frames

445015262 rx data frames

442787414 rx unicast data frames

1843973 rx multicast data frames

383875 rx broadcast data frames

65579149 rx management frames

8437559 rx control frames

0 rx unknown frames

8437554 rx BAR (Block Ack Request) frames

519031970 11n rx frames

0 rx chip keyix errors

0 rx chip antenna errors

0 rx chip short frame errors

0 rx ieee queue depth

7705976 rx Retries

1% rx retry rate

133869200 rx CRC errors

20% rx CRC rate

2735 rx frame errors other than CRC

0 hw FIFO overrun

336 decryption failed

0 MIC failure

575 rx frames dropped

187 frame too short

388 frame too large

0 frame in other mode

0 rx dropped because no skbuff

380336376 tx data frames

361890360 tx unicast data frames

13408247 tx multicast data frames

5037769 tx broadcast data frames

--------------------------------

379768701 tx WMM best effort data frames

1002 tx WMM background data frames

564482 tx WMM video data frames

2191 tx WMM voice data frames

11649508 tx management frames other than beacon

127244205 tx beacon frames

0 tx beacon frame stucks

0 PCI errors

39415 tx BAR (Block Ack Request) frames

64735796 tx aggregated completions

0 tx BAR (Block Ack Request) frames dropped

0 invalid tx rate index

0 invalid rx rate index

51371 tx retries

49 tx RTS failures

51322 tx retries

0% tx retry rate

0% unicast data tx retry rate

0 tx retries of sub frames

0 tx frames with no ack marked

12883452 tx frames with rts enabled

0 tx frames with cts enabled

0 tx frames with short preamble

371821 tx frames with an alternate rate

12883452 tx frames with protection

3362860 tx frames dropped

3362860 no tx buffer (data)

0 no tx buffer (mgmt)

64045 tx frame errors

64045 too many hw retries

0 hw FIFO underrun

0 transmit filtered by hw

0 tx transmit queue full

1024 tx available buffers

0 exceeded txop

0 exceeded tx timer

1648264 tx frames succeed

120708 tx frames failed

44 rx rssi from histogram

0 no skbuff available for beacon

0 switched from HT40 to HT20

0 switched from HT20 to HT40

500871 channel switches

0 AMRP one-way neighbor timeout detected

1220 interference raise alert

1219 interference clear alert

0 band steering suppress

0 load balance suppress

0 weak snr suppress

0 safety net bypassed suppress

 

 

1 REPLY 1

itadmin5
New Contributor

Ran: show acsp neighbor

Results in attached file

 

 

GTM-P2G8KFN