You can set a static IP on a device within HiveManager (formerly NG), by going to Monitor> Clicking on the host name of the device> Device Configuration> Under the Management Interface section select "Static Address" and fill in the IP, subnet mask, and default gateway that the device should be using. Once you push a complete configuration out to this device, it should be using a static DHCP address.
You can also set the IP address on the CLI of a device by entering the following commands:
Int mgt0 ip <ip address> /<netmask>
Ip route default gateway <address>
save config
Keep in mind that commands in the CLI that conflict with the configuration in HiveManager get erased/overwritten when configuration updates are pushed out or when the AP reboots.
Is that what you were looking for?
