cancel
Showing results for 
Search instead for 
Did you mean: 

which one is the mesh point and which one is the bridge on ap 1130. also how to change a ap 1130 from being an inside to outside device..aeohive support has change the ap 1130 from being an outside to inside device.

which one is the mesh point and which one is the bridge on ap 1130. also how to change a ap 1130 from being an inside to outside device..aeohive support has change the ap 1130 from being an outside to inside device.

parsonsb
New Contributor
which one is the mesh point and which one is the bridge on ap 1130. also how to change a ap 1130 from being an inside to outside device..aeohive support has change the ap 1130 from being an outside to inside device.
1 ACCEPTED SOLUTION

samantha_lynn
Esteemed Contributor III

When you deploy a mesh setup, you will want to push the configuration out to the Remote AP first (the one that will not have a physical connection). Once that is rebooting, push the configuration out to the Portal AP (the one that will have a physical connection). If you're asking which ports are doing what, you should check your device specific settings to see what you have set it to use.

 

There is no setting to set an AP 1130 to be "inside" or "outside", it can do either. There are some power and mounting recommendations depending on which option you choose, and you can view those recommendations here- https://docs.aerohive.com/330000/docs/help/english/ng/Content/hardware/ap/ap1130.htm?Highlight=indoor

 

 

View solution in original post

1 REPLY 1

samantha_lynn
Esteemed Contributor III

When you deploy a mesh setup, you will want to push the configuration out to the Remote AP first (the one that will not have a physical connection). Once that is rebooting, push the configuration out to the Portal AP (the one that will have a physical connection). If you're asking which ports are doing what, you should check your device specific settings to see what you have set it to use.

 

There is no setting to set an AP 1130 to be "inside" or "outside", it can do either. There are some power and mounting recommendations depending on which option you choose, and you can view those recommendations here- https://docs.aerohive.com/330000/docs/help/english/ng/Content/hardware/ap/ap1130.htm?Highlight=indoor

 

 

GTM-P2G8KFN