Hello. I tried ro make port-channel as L3 interface but can't assign ip-address on it and have no success. Please help.
TESTWASH(config-Port-channel-30)# do sh run int e 0/1interface Ethernet 0/1 channel-group 30 mode active type standard lacp timeou...
When I try to configure a trunk port on the slx 9140 I get following error
Testsystem02(config)# interface Ethernet 0/1
Testsystem02(conf-if-eth-0/1)# Switchport mode trunk
%%Error: Interface not bound to bridge
Testsystem02(conf-if-eth-0/1)#
D...
Has anyone already experience in integrating Brocade G610 FC Switches into Netsight?
What Features are supported (FW Backup and Update especially?)
Thx in advance for any info on that
peter
Please I will appreciate your assistance with an issue with a Brocade Big iron RX8 switch. The switch has not been in use for quite some time. It was recently powered up with modules inserted. After booting, a 24 port 1G SFP module was not passing...
