Data Center (SLX) - Page 26 - Extreme Networks

Data Center (SLX)

Questions and discussions about SLX

Forum Posts

Sorted by:

Start a conversation

SLX 9140 ip-address on layer 3 port-channel

Hello. I tried ro make port-channel as L3 interface but can't assign ip-address on it and have no success. Please help. TESTWASH(config-Port-channel-30)# do sh run int e 0/1interface Ethernet 0/1 channel-group 30 mode active type standard lacp timeou...

slx 9140 trunk configuration

When I try to configure a trunk port on the slx 9140 I get following error Testsystem02(config)# interface Ethernet 0/1 Testsystem02(conf-if-eth-0/1)# Switchport mode trunk %%Error: Interface not bound to bridge Testsystem02(conf-if-eth-0/1)# D...

Brocade G610 FC Switch Integration in Extreme Management

Has anyone already experience in integrating Brocade G610 FC Switches into Netsight? What Features are supported (FW Backup and Update especially?) Thx in advance for any info on that peter

Brocade Bigiron RX8 invalid module

Please I will appreciate your assistance with an issue with a Brocade Big iron RX8 switch. The switch has not been in use for quite some time. It was recently powered up with modules inserted. After booting, a 24 port 1G SFP module was not passing...

Updated Visio Stencils for ExtremeSwitching and ExtremeWireless

Extreme's external https:// https://www.extremenetworks.com/support/visio-stencils/ has recently been updated with latest Visio libraries. Stencils for ExtremeSwitching, ExtremeWireless, including Avaya-heritage and Brocade Data Center products can ...

Top Kudoed Authors

User

Count

10

1

1

1

1

GTM-P2G8KFN