Hello Experts,
I have created the below PBR but it is not working as per expectation.
Configuration :
===========
rbridge-id 1
route-map PBR_TEST permit 10
match interface te 1/0/3
set ip next-hop 192.168.31.2
exit
ip route 10.10.10.0/24 192.168.21.10
arp 192.168.21.10 0000.0000.2110 interface te 1/0/3
arp 192.168.31.2 0000.1234.5678 interface te 1/0/4
exit
interface te 1/0/2
ip address 192.168.11.1/24
ip policy route-map PBR_TEST
exit
interface te 1/0/3
ip address 192.168.21.1/24
exit
interface te 1/0/4
ip address 192.168.31.1/24
exit
Outputs:
=======
extreme01# show route-map PBR_TEST
Interface Te 1/0/2
ip policy route-map PBR_TEST permit 10
set ip next-hop 192.168.31.2
Policy routing matches: 0 packets Note: No counters available
extreme01# show ip route-map PBR_TEST
route-map PBR_TEST
seq 10
match interface Te 0/3
set ip next-hop 192.168.31.2
Above both outputs contradict as one shows a match condition and the other does not.
Packet test result :
==============
packet injected from Te 1/0/3 with ipv4_src 192.168.11.11 & ipv4_dst 10.10.10.1 , Packet coming out of the interface Te1/0/3 but as per PBR it should come out from Te 1/0/4
how does the switch check the Match condition here as Te 1/0/3 doesn’t have PBR on it, so when traffic ingress from Te 1/0/3 how it will go to PBR for Match validation?
-Pavan Pawar
