Extreme Networks

pawarpavan · 08-21-2023

Hello Experts,I'm configuring the TACACS+ on the VDX switch and I was able to configure 'aaa authentication and aaa accounting' but did not find an option to configure authorization even though I have configured the tacacs+ host. extreme01# show runn...

pawarpavan · 08-20-2023

Hello Experts,I see below two routes v6 on the switch, I did not configure them but it's there even after wiping the config.extreme01# show ipv6 route IPv6 Routing Table for VRF "default-vrf"Total number of IPv6 routes: 2'[x/y]' denotes [preference/m...

pawarpavan · 08-08-2023

Hello Experts,Does VDX support PBR with IPv6.I have configured IPv6 standard and extended ACL , matched them in route-map then set ipv6 next-hop lastly applied route-map to the interface but traffic is not being routed as per policy. So want to confi...

pawarpavan · 07-25-2023

Hello Experts,I have created the below PBR but it is not working as per expectation.Configuration :===========rbridge-id 1route-map PBR_TEST permit 10match interface te 1/0/3set ip next-hop 192.168.31.2exit ip route 10.10.10.0/24 192.168.21.10arp 192...

pawarpavan · 07-21-2023

Hello Experts,Does VDX support IP SLA feature?If yes then can I get config guide or steps to enable it -Pavan Pawar

pawarpavan · 08-01-2023

so in this case match interface criteria is not supported?As we are applying PBR at interface Te 1/0/2 and matching interface Te 1/0/3,so how Te 1/0/3 will send the traffic for PBR inspection if it's not applied on it?

pawarpavan · 07-13-2023

Ok,is it software version specific or hardware specific

pawarpavan · 07-12-2023

Hello Deep,Thanks for taking a look at the request.I can enable the vrrp-extended on the switch for IPv4 but there is no option to enable VRRP version 3 under it, Refer to config snip :extreme01(config)# rbridge-id 1extreme01(config-rbridge-id-1)# pr...

pawarpavan · 06-30-2023

Thanks, Michael for your amazing support.there is a small correction in the syntax :deny 8759.7ca3.0000 FFFF.FFFF.0000 host 4ab3.1761.818aThis will match any MAC from 8759.7ca3.0000 - 8759.7ca3.FFFF

pawarpavan · 06-15-2023

Thanks for sharing the information.Does it support CDP because I enabled it in the config(protocol cdp) but could not find the command to check the CDP neighborextreme01# show running-config protocolprotocol lldpadvertise dcbx-fcoe-app-tlvadvertise d...

Extreme Networks

User Statistics

User Activity

Brocade VDX - TACACS

Brocade VDX - IPv6

Brocade VDX 7.0.3a - PBR with IPv6

VDX6740 - PBR match interface Te 1/0/2(version 7.3.0)

VDX6740 (7.3.0aa) - IP SLA

Re: VDX6740 - PBR match interface Te 1/0/2(version 7.3.0)

Re: VDX6740 : VRRP-Ev3-IPv4

Re: VDX6740 : VRRP-Ev3-IPv4

Re: MAC Extended ACL / MAC-Address subnet mask calculation

Re: VDX 6740 supported feature