New Documentation Published April 28th- May 18th!

[SamPirok]

Our support teams published 152 new articles over the past few weeks! Check out the new titles below!

All

RADIUS Dot1x Troubleshooting for XCCv5 and XIQ-Cv10 onPrem WiFi Controllers 

Campus Fabric Articles

Do vIST peers synchronize ARP table? 

Is CLI Command Available To Disable Fragmentation In Pings From VOSS/Fabric Engine 

Voss /FabricEngine – How To Troubleshoot Reports of Network Latency or Lost Packets on Campus Fabric... 

VOSS: System Stops Responding To SNMP Inquiries 

Is there a quick way to default a VOSS interface?

VSP8600 : 8600SF shows above 40% CPU utilization 

ERS : How to configure MLT with LACP? 

VOSS: Cannot change/Remove ISIS Manual Area 

VOSS (FE): Missing ISIS routes in certain VRF 

VOSS BGP routes leak though route-map (Display issue only) 

Resolve loops forming between two fabric areas 

SNMP configuration issues due to permissions 

VOSS FDB entries not flushed when TCN received 

Fabric Engine: How to configure Active Timeout for IPFIX? 

Discrepancy between Alarms Logs Reference Guide and Switch Log 

show fulltech too big and never ends due to lldp neigh detail info looping 

VSP8400 DHCP stopped working after migration from S4 switch 

How to configure ACL to deny RDP(remote desktop Protocol) from x to y network? 

VOSS: 8.1.4: Invlan ACL dropping VRRP hello packets on vist resulting into Master Master on both vis... 

SSH Key exchange method used by VSP and ERS switches 

Is 'ip tcp adjust-mss' Supported For Non-Fabric Extend Traffic 

Can DHCP-Server Running On VOSS Be Configured For Option 43 

Manage VOSS configuration via Cloud IQ 

VOSS Auto-nickname feature 

VOSS: HID VertX EVO V2000 Controller Randomly Loses Or Fails To Establish Physical Ethernet Connecti...

Data Center Articles

TM NIF errors message 

XCO GUI device overview page missing graphs/charts 

XCO GUI shows device upgraded successfully but device page shows old firmware version instead new ve... 

Interface is not sending out traffic after change from FCOE to Ethernet 

Incorrect value in Ethernet tag id on NLRI BGP EVPN update 

Cannot SSH to the SLX8520 

Packet Broker Ingress Tap Port Showing Discards 

Extreme Branded 10BaseZR SFP+ optics show as 10BaseER on NI with 6.3e 

ZTP install: Ubuntu packages are broken during XCO installation phase 

Port channel/connection/link went down on 2 ports 

SLX9240: With burst traffic,Drop is seen on 40Gig if it reaches a port rate of more than 25% i.e. 10... 

Metro Ethernet connection stuck in Up/Protocol Down state on VDX8770 

Wrong information on the file "Layer 2 Switching Configuration Guide" for Extreme SLX-OS. 

All the data Interfaces failed on SLX 8820 

BGP daemon is crashing continuously after few days after upgrading to 20.5.2a code 

Is there an OID for power supply status for SLX? 

What this console output means " BIOS 3A14 POST starts... [11][32][15][19]" 

Tx and Rx High-Alrm on several ports 

Need your support to configure SNMP 

SLX is Calculating next hop' message in terminal monitor in 20.5.3 

DHCP Discover messages are dropping on MLX 

License Generation Failed - Maximum Capacity 8 activated for feature 100G 2C No more feature 100G al... 

BGP neighbors flapping due to hold timer expired 

What information need to be collected if Data traffic forwarded with incorrect next-hop MAC address.... 

If MLX 6.300h has been stable do we have to upgrade to 6.3.00j recommended code 

The "show tm voq-stat ingress-device all discards" Counters Not Updating

EXOS Articles

What EXOS traps are associated with remote telnet/ssh connections 

Packets are authenticated on ports blocked by STP 

SA-2024-042 - EXOS Privilege Escalation via Python MMI (CVE-2024-27453) 

Access ports are seen as interswitch links during ZTP+ 

VPEX upgrade via "Install image" command does not work for .lst files located in local file system 

Switch reboots due to VLAN process running out of memory 

'unconfigure switch all' fails in roughly 2 out of every 100 trials 

PC, Printers authentication is not working that are connected to ReachNXT device 

Unable to change password on defaulted switch 

Process VLAN crash with signal 6 after upgrade to 32.7.1.9 

Unable to ssh into switch with error "no matching host key type found. Their offer: ssh-rsa" 

How to push/assign a static IP to the Management Interface Settings via XIQ 

Issue with VPLS/VPWS service with name size of 32 characters exactly. 

Ping to VRRP VIP fails when passing through VRRP backup node in MLAG topology with Fabric-Routing en... 

How to configure H-VPLS? 

OSPF process crash when one of ospf link flaps-Process-ospf-pid-3248-died-with-signal-4 

SA-2024-051 - ICMP netmask request response (CVE-1999-0524) 

4120 Series Diagnostic Failure 

General Articles

ISW Switch 168xx generates frequent error logs after dot1x authentication

IdentiFi Articles

How to rest E1120 to factory defaults via the cli 

License warning. There are more approved Devices than permitted by the license. X days left in grace... 

XIQ-C - AP fails to upgrade claiming possible corrupt firmware 

Legacy Articles

SD-WAN licenses assigned in the MSP Workspace does not show up in the VIQ 

How to reset the admin password on a Node of a UCP Cluster 

Gui access sluggish on a node in a UCP cluster 

What is 802.11ax (Wi-Fi 6)? 

AP is not receiving full BT POE

SD-WAN Articles

What are the Fabric over SDWAN limitations? 

What does the alarm "OutOfDpiContexts" mean? 

Missing XIQ map prevent the Onboarding of new SDWAN sites 

Why am I seeing the error "unable to retrieve SaaS Dictionary informations" after uploading the SaaS... 

Why does the domain have a red LED with an error message "The following domains are not configured" ... 

How to check the issue with Active Directory authentification on SALSA? 

What are the 4 ZTP states? 

Advanced Troubleshooting for the Internet Access feature 

How to collect data (reports) from teleengines? 

Universal Articles

5420 shows error messages if the USB flash drive is removed before executing "eject usb" 

WiNG Articles

ADSP Account Max Login Attempts setting does not show config that is already set 

AP5010 rolls back to default configuration on WiNG after first adoption 

AP7532 - no longer providing internet after power outage 

AirDefense Platform Manual Redundant Appliance Synchronization Not Working 

6E radio chart in NOVA is missing 

[WiNG] Meshpoint can't be configured on AP4xx and AP310-1 GUI 

How to set up MAC authentication on the Captive Portal(WING) enabled wlan 

Trustpoint not uploading to AP's

XIQ Articles

IQ-Engine - Why does the "show interface wifi" command show a different EIRP output power than the "... 

XIQ-C API call to find aps by mac address 

XIQ Japan RDC - Adjust Firewall Rules to accommodate new IP address block 

410c not bringing backup tunnel up 

XIQ-C how to set bearer token expriy time 

iPhones using webex calling getting garbled/choppy reception 

What do the badges on the floorplan mean? 

XIQ-C- one wlan coming up with ssid hidden after enabling session persistence 

NRG 3125 radclient core files 

Some aps do not show RSS or SNR on floorplan and instead show N/A 

XIQ - How to enable and configure Weak Signal Probe Request Suppression 

APs with high airtime utilization and port efficiency error can be seen on Co-pilot 

What is default-security-object observed in client trail? 

Co-Pilot License grace period alert for locally managed devices 

XIQ-Controller onboard via web proxy feature 

XIQ - AP reboot cause compilation 

XIQ Sweden RDC - Adjust Firewall Rules to accommodate new IP address block 

Suddenly unable to connect to SSID - clients getting "Incorrect PSK" message 

Why All Access Points request a DHCP management address at reboot even though static is configured 

Supplemental CLI is ignored on XIQ 

Filter does not appear under Monitor > Clients 

What does the CloudIQ status icon mean on the controller? 

Why link in XIQ to XIQ-SE using Local IP and not DNS Hostname 

XIQ | AP330 config update failure error 

ExtremeCloud IQ Controller registered device list in Captive Portal Administration only displays 50 ... 

Can monitor OFDMA in ExtremeCloud IQ? 

IP adresses observed hit and blocked towards SE RDC for Extreme Cloud IQ 

Devices Intermittently losing connectivity to default gateway. 

A wireless users role (filters rules) are overwritten by the AP VNS default configured values. 

XIQ - Is it possible to use MU-MIMO and OFDMA at the same time? 

How to remove AP from XIQ-C 

A deeper look into ACSP 

Radius configuration question 

How do I show the certificate for an AP39XX from the CLI? 

ExtremeCloudIQ-new-alerts-page-stopped-working-After May 5th 2024 

XIQ - How to get firmware upgrade notifications 

Is 6ghz supported on outdoor Mesh deployments? 

Does Schedule Docker sync in a high availability pair? 

Which email domains are not allowed to be used to register for an ExtremeCloud IQ account? 

When do APs change their channeling? 

ExtremeCloud IQ Controller with licensed for Egypt may not show the configured Site 

XIQ - Does PPSK block mac address of failed clients 

[XIQ-C] question for default config change after firmware update. pse: disable -> enable 

XIQ-C shows Certificate: Expiring Warning 

Why is AP230 is not able to upgrade to latest 10.6.1 IQ Engine firmware 

Why does attempting to SSH into the Aerohive APs devices sometimes result in the error message "Coul... 

XIQ - How to enable 802.11w Protected Management Frames 

How to add/delete/edit MAC Objest on XIQ 

XIQ | AP4000 not broadcasting SSID on firmware version 10.4r0 

APs not receiving DHCP address from DHCP server - stuck with 192.168.X.X IP addresses 

XMC Articles

Is it possible to disable 802.1X EAP-MD5 on the NAC Appliance 

Drill down issue with application dashboard 

Adding filter on Analytics Application Flows destroys UI, requires refresh 

Extreme Management Center crashes when adding x870 with VPLS configuration

If you have any requests for new articles, please let us know! You can either comment on this post, or email me directly at community@extremenetworks.com.