04-03-2023 05:45 AM
Our support teams published 76 new articles last week! Check out the new titles below!
Campus Fabric Articles
Incorrect IP address assigned to PC from the DHCP server
"Error: Failed to create user" When Trying To Add Username Containing a Period/Dot
VSP 4900: Stopped responding, lot of diagnostic data printed on console
VOSS / Fabric Engine – Traffic Flood Causes Congestion on Next Hop Device
VSP7400: Switch cored with Error "carbonatelib_ps_read_eeprom"
Does EDM Support Multiple rwa User Accounts
Fabric Engine : MAC address visible on wrong port on a MAC security enabled switch
ERS 4900: Radius parameters for BOSS
XA1480: No ARP resolution in mgmt VLAN
[VOSS] VSP/ERS Should SLPP be configured on an FE (Fabric Extend) connection
How to associate port to existing elan i-sid (flex-mode UNI)?
VOSS: How to convert the Hex value to decimal for OID rcVlanPortVlanIdList?
Data Center Articles
Power supply down on BR-VDX6940-36Q chassis
When adding an IP address to VRF mgmt interface the ip gateway address is listed as 0.0.0.0
DHCP relay does not work with anycast-address
Increasing LLDP Errors between SLX 9250 and HP server
Missing REST- and NETCONF documentation about service-policy configuration
Root password reset to default after SLXOS upgrade through fullinstall option
How to add extra user access account in EFA/TPVM other than default extreme user
Why do VxLAN tunnels show operational state down for some rbridges in a VDX fabric?
Application Communication Failure error when entering any NOS CLI command.
Cluster Peer Keep-Alive down after changing the management IP address of the peer
EXOS Articles
Unable to enforce vlan definitions on EXOS switch with XIQ-SE
Can an External STK-RPS-1105PS be installed on an active X440-G2 switch?
General Articles
Legacy Articles
How can you tell if a device is using a randomised MAC address
After upgrade XIQ-C controller to 10.04.01 the management interface is slow to respond.
Scheduler for Extreme Campus Controller doesn't change time for daylight savings
How to setup Extreme Cloud IQ Controller physical management interface through CLI
XIQ-C - Controller UI is hanging when attempting to make config changes
SD-WAN Articles
Why does the error "Purge event histories" appear in the vistacokpit server?
Universal Articles
Is FCoE (Fiber Channel over Ethernet) Supported on VOSS/VSP Switches
How to copy Fabric IPSec Gateway (FIGW) files to VOSS intflash ?
DHCP Reply isn't received by the computer.
Can rw Access-Level User Be Configured for EDM Access
How to set up Fabric IPSec Gateway (FIGW) time and time zone ?
What is VRRP Fast Advertisement Enable?
WiNG Articles
What protocol is used to secure management traffic between wing AP and external radius server?
How can we disable routing services on WiNG devices?
WiNG 5 Minimum Firmware Version for AP76xx to upgrade to WiNG v7.7.x.x
Generic AP profile RF Mode error [rf-mode 6GHz-wlan is not supported on radio3]
WiNG AP460 allows the antenna to be incorrectly configured to 4x4 on radio 1
Wing Manager v1.0.9 for MAC OS Delayed
XIQ Articles
APIv2 GET devices request problem: returning duplicate AP list entries in last page
ExtremeCloud IQ: How to view all AP connected to a specific SSID?
High CPU usage on AP's with the highest process "ah_dcd"
Client trail is not showing all events
Are there any special characters not allowed to be in PPSK password?
License Expiration Notice: Some assigned entitlements expire in X Days
Are there any special characters not allowed to be in PPSK usernames?
Why are my APs set to 2.4GHz but broadcasting 5GHz?
XIQ-C | Clevertouch panels disconnecting from MBA SSIDs
The number of activated licenses doesn't match the number of online devices on XIQ
What will happen to APs managed in HMOL (HiveManager Classic) when it discontinues?
Where to find XIQ - Network 360 Plan?
How to disable LEDs on specific Access Points in ExtremeCloud IQ
VLAN creation is not possible in private XIQ
XIQ - Alert email notification before the subscription license expires
What is the end of life plan for Hive Manager Online (HMOL)?
WEB GUI in XIQ doesn't allow changing Advanced Access Security Controls in SSID settings
Is it possible to configure AP5010 to operate in dual or triple 5 GHz mode?
Newly added AP is not showing up on the Manage Devices page in XIQ
If you have any requests for new articles, please let us know! You can either comment on this post, or email me directly at community@extremenetworks.com.