How to change IP Address on ECA physical management interface through CLI?

[huhuan]

How to change IP Address on ECA physical management interface through CLI?

[Ronald_Dvorak]

Hi,

please check out the below KB article with the answer….

https://gtacknowledge.extremenetworks.com/articles/How_To/000038942

-Ron

[SantM]

run cli-wizard and change the parameters you want.

[Gareth_Mitchell]

Hi

See below example:

xca-3.extreme-test.com:topology# show
                                                                                                                        
Name                    Mode      L2:VlanId,tagged,port  L3:IP,GW,DHCP                 L3:IPv6,Auto-Generated           
                                                                        
physical 1              physical  10,disable,Port1       192.168.0.101,none,none                                        
                                                               
                                                                                                                        
xca-3.extreme-test.com:topology# "physical 1"
xca-3.extreme-test.com:topology:physical 1# l3
xca-3.extreme-test.com:topology:physical 1:l3# show
Layer 3 presence: enable
Interface IP 192.168.0.101 255.255.255.0
AP Registration: enable
Allow management traffic: enable
Factory default certificate/key
MTU: 1500
FQDN:
xca-3.extreme-test.com:topology:physical 1:l3#  ip ?
Error: invalid ip address input.
Usage: ip A.B.C.D/<0-30>

After you set the ip address, type “apply”

-Gareth