create a port specific alarm in netsight
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-01-2014 01:21 PM
how i can create a alarm from specific port in switch ?(x450,x670,x460)
17 REPLIES 17
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-03-2016 05:34 PM
But...
We are trying to monitor only the uplink ports of Extreme switches park (all x440 - XOS 15.7.1.4).
Without the Port Elements Group, the Alarm "Link down" and "Link Up" detect the status of the ports and generate Alarms, but with the Port Elements Group on any port, generates no Alarm.
Netsight 6.2 here.
EDIT:
complementing ... during testing, the NetSight records the fall of the link in the syslog and trap
We are trying to monitor only the uplink ports of Extreme switches park (all x440 - XOS 15.7.1.4).
Without the Port Elements Group, the Alarm "Link down" and "Link Up" detect the status of the ports and generate Alarms, but with the Port Elements Group on any port, generates no Alarm.
Netsight 6.2 here.
EDIT:
complementing ... during testing, the NetSight records the fall of the link in the syslog and trap
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-23-2015 06:02 PM
So,
I have more than 10 ports in the same group, are my trunk and uplink ports the software consider just if all ports goes down or not?
I have more than 10 ports in the same group, are my trunk and uplink ports the software consider just if all ports goes down or not?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-23-2015 06:02 PM
Responding to my brother...
Even having a "trunk" doors, the NetSight will monitor each port individually.
Example here:
# enable sharing 1:24 grouping 1:24 2:24 algorithm address-based L2
If the status of the door (2:24) was changed to down, the Alarm "Link down" will indicate the fall of the door. The same goes for the door 1:24
Even having a "trunk" doors, the NetSight will monitor each port individually.
Example here:
# enable sharing 1:24 grouping 1:24 2:24 algorithm address-based L2
If the status of the door (2:24) was changed to down, the Alarm "Link down" will indicate the fall of the door. The same goes for the door 1:24
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-23-2015 05:59 PM
@Ron,
I got it receive this message bellow with your test advice...
Conditions: IP: $ipaddress MAC: $macaddress However continue without message when ports goes down.
I got it receive this message bellow with your test advice...
Conditions: IP: $ipaddress MAC: $macaddress However continue without message when ports goes down.
