cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

create a port specific alarm in netsight

create a port specific alarm in netsight

jaime_quintana
New Contributor
how i can create a alarm from specific port in switch ?(x450,x670,x460)
17 REPLIES 17

Murilo_Melo
New Contributor
But...

We are trying to monitor only the uplink ports of Extreme switches park (all x440 - XOS 15.7.1.4).

Without the Port Elements Group, the Alarm "Link down" and "Link Up" detect the status of the ports and generate Alarms, but with the Port Elements Group on any port, generates no Alarm.

Netsight 6.2 here.

EDIT:
complementing ... during testing, the NetSight records the fall of the link in the syslog and trap

Tavares_Belmont
New Contributor II
So,

I have more than 10 ports in the same group, are my trunk and uplink ports the software consider just if all ports goes down or not?

Responding to my brother...

Even having a "trunk" doors, the NetSight will monitor each port individually.

Example here:
# enable sharing 1:24 grouping 1:24 2:24 algorithm address-based L2

If the status of the door (2:24) was changed to down, the Alarm "Link down" will indicate the fall of the door. The same goes for the door 1:24

Tavares_Belmont
New Contributor II
@Ron,

I got it receive this message bellow with your test advice...

Conditions: IP: $ipaddress MAC: $macaddress However continue without message when ports goes down.
GTM-P2G8KFN