cancel
Showing results for 
Search instead for 
Did you mean: 

I don't receive traps from switch which is managed through management port

I don't receive traps from switch which is managed through management port

JohanHendrikx
Contributor II
I have some switches connected through the management port.

For some reason I don't receive any traps when a port went down or a EAPS change happend

Johan Hendrik System Architect Audax
14 REPLIES 14

Ronald_Dvorak
Honored Contributor
Hi Johan, could you please post the output for "show config | incl target-addr".

Do you rx any traps at all ?
Could it be that you haven't set vr-mgmt as the vr to forward the traffic.

Clear counters, disable and enable a port and then do "show management" there will be counters for traps sent check whether this counter incrementing.

View Name : defaultUserView
MIB Subtree : 1.0
Mask : 80
View Type : Included
Storage Type : NonVolatile
Row Status : Active

View Name : defaultUserView
MIB Subtree : 1.3.6.1.6.3.16
Mask :
View Type : Excluded
Storage Type : NonVolatile
Row Status : Active

View Name : defaultUserView
MIB Subtree : 1.3.6.1.6.3.18
Mask :
View Type : Excluded
Storage Type : NonVolatile
Row Status : Active

View Name : defaultUserView
MIB Subtree : 1.3.6.1.6.3.15.1.2.2.1.4
Mask :
View Type : Excluded
Storage Type : NonVolatile
Row Status : Active

View Name : defaultUserView
MIB Subtree : 1.3.6.1.6.3.15.1.2.2.1.6
Mask :
View Type : Excluded
Storage Type : NonVolatile
Row Status : Active

View Name : defaultUserView
MIB Subtree : 1.3.6.1.6.3.15.1.2.2.1.9
Mask :
View Type : Excluded
Storage Type : NonVolatile
Row Status : Active

View Name : defaultAdminView
MIB Subtree : 1.0
Mask : 80
View Type : Included
Storage Type : NonVolatile
Row Status : Active

View Name : defaultNotifyView
MIB Subtree : 1.0
Mask : 80
View Type : Included
Storage Type : NonVolatile
Row Status : Active

Total num. of entries in vacmViewTreeFamilyTable : 8

Johan Hendrik System Architect Audax

Could you check whether the MIB-View is configured?

show snmpv3 mib-view

configure snmpv3 add target-addr "v1v2cNotifyTAddr1" param "v1v2cNotifyParam1" ipaddress 144.2.144.77 transport-port 162 vr "VR-Mgmt" tag-list "defaultNotify"

From this device I don't receive any trap at all. From other devices ( management not through mgmt port) I receive traps.

Johan Hendrik System Architect Audax
GTM-P2G8KFN