OneView cannot access Purview server, error states "appliance is not running"

[Steve_Ballantyn]

I have a wireless controller with esa0 set up as lag1, and esa1 set up as a mirror. My esa1 connects directly to a NIC on my VMWare server (promisc' set to permitted), and this NIC is connected directly to esa1 on my controller. A simple setup, I think.

When I go into OneView, add my EWC as a Wireless Control Flow source, and then try to Enforce those settings, I get "1 appliance is not running".

Anyone have any clues for me?

Here are some screenshots of my setup ...

My EWC ...

My Purview appliance ...

My OneView settings ...

[Jeremy_Gibbs]

Does ifconfig on the purview appliance show the interfaces you would expect?

[Steve_Ballantyn]

Hello Ron, I am getting a "sensor is down!" error. Here is a screenshot.

[Jeremy_Gibbs]

Maybe this will help:

https://gtacknowledge.extremenetworks.com/articles/Q_A/Wants-somebody-to-review-his-Purview-config-t...

And

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-configure-Identifi-Wireless-Control...

[Steve_Ballantyn]

The two KB's checked out ... with the exception of not being able to enforce my Purview appliance, and when I do a tcpdump -i eth1, I am seeing ZERO traffic. Which I suppose would make sense if the appliance cannot be enforced! 🙂