Guide XMC configuration
Hello everybodyI would like to be able to configure an XMC with NAC and Radius over 802.1X for a wired network.Can you help me with this? Does anyone have a guide or example on how to set it up?Thanks in advance. Regards.
Forum Posts
How avoid that uplink interface of cisco switch with x450-G2 switch fill up the end-system table of my Extreme Control engine with mall mac that ear on the access vlan
Hi,I've got in my lab an x450-g2 switch and connected to one port of this in trunk mode, there is a cisco switch (on cisco the uplink port is gigabitethernet0/1).When I connect the cisco to the x450-g2 switch, the end-system table of the control engi...
XIQ-SE: archive of EXOS switch with other VR-default config doesn't work
Hello For a Customer we upgrade XMC to XIQ-SE. Sins that moment the archive of the Switches with there management IP adres connected to a other VR than vr-default, doesn't work. In XMC it did work ( years ago we make a copy of the exsting archive sc...
Revome a device from the Discovered Tap in XIQ-SE after a faild ZTP+ process.
Hallo all,I added a EXOS switch X435-24t-4s to the XIQ-SE via ZTP+ and the following happend: - The switch upgraded to the Ref. frimware. - ZTP+ Config failed (regardless of the reason) - I wanted to delete the deivce from the Discovered Tab but it ...
Resolved! XMC search for devices with specific VLANs
Is there a way inside XMC to search or run a report for all the switches in my environment that have a specific VLAN ID programmed in them? Ex. Display all switches that have vlan 110
