cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

This user does not have permissions for this command.

This user does not have permissions for this command.

Giuseppe_Montan
Contributor
Good Afternoon,

X440 connected to XMC/NAC used to autheticate the user for management login.

IF I try to connect to the switch with ssh the prompt is this :

X440_UP > and for any command I do I receive this error:

"This user does not have permissions for this command."

The problem is the connection to radius ( XMC/NAC ) but I do not know where ( I only upgraded to the last release XMC and NAC )

Thanks
Giuseppe
18 REPLIES 18

Zdeněk_Pala
Extreme Employee
Sorry. It is more complex. Here is the documentation for EXOS 16.1 = https://documentation.extremenetworks.com/exos_16.1/downloads/GUID-D14940D6-7F4E-4084-A9BD-069AA223D632.pdf
What you need is the Security section, pages 951+

In general you need to authenticate the user through Radius with Extreme-CLI-Authorization = enabled.
then you will receive each command through radius request and Access-accept means the command can be executed. Access-reject means the command execution is rejected.
Regards Zdeněk Pala

JASU
New Contributor
Would you share example to show steps from both switch & radius server ?

Zdeněk_Pala
Extreme Employee
The per-command authorization can be used for this purpose. The EXOS needs to be configured to request permission for each command. the Radius needs to approve/reject each command.
Regards Zdeněk Pala

JASU
New Contributor
Is there a way to grant the user with read-only privilege to run "Show configuration" ? Or any equivalent command to show complete configuration ?
GTM-P2G8KFN