XMC and Reload Device action

[dsireseau]

Hi,

I have two question about "reload device" function in "configure" screen which allows to upload switches running's configuration into xmc's database.


A) Do somebody knows any reason why "reload device" action takes about 5 minutes to finish on a X440-G2 and just 15 seconds on a A-series ?
Sometimes it takes more than 10 minutes.


All devices configured with snmpV3
same vlan, same ip subnet
Summit X440 version : 22.7.1.2
A4 version : 06.81.10.0001
XMC version 8.3.1.9


 Is there a way to schedule reload every day by a script to ensure xmc database in always up-to-date in case of changes by ssh cli (port config or vlan creation)


Thanks for your replies.

Cedric

[dsireseau]

Hello,
It's in progress

[Zdeněk_Pala]

You should probably contact GTAC for additional help.

[dsireseau]

Ok, that's why ssh and http(s), thanks

Switches are stacked but A4 are too ....
Vlan number varies with switches but stays under 15

Il tried to use snmpV1 but it's quite long too (4-5 minutes versus 8-10 with snmpV3)
I'm loss 😞

Thanks

[Zdeněk_Pala]

Extreme Management Center does try to get information from Securestacks only through SNMP and there is much less of information we do gather compare to EXOS.

From EXOS we gather information through SNMP and http/https and CLI = check if all methods are available & working.

Do you have stack or EXOS or single unit? more ports => more time. more vlans => more time.